|
How
to Install your Heavy
Duty Wall Hanger
 1.
Remember,
no need to locate wall stud because this hanger works
without studs - uses strength of wall panel to support
weight! Simply mark spot on wall where you want
base of hook to be. Then mark second spot
approximately 1/4" above first spot. This is point
where hanger should be inserted.
2.
"Drill" chisel end of
hanger into wall by twisting hanger back and forth with
your hand. Force chisel point into wall as you
twist. (On old-style plaster/lathe walls, pre-drilling
may be required.)
 3.
After
chisel point passes through wall, twist hanger so hook
end is upright. Then push balance of hanger into
wall until only hook is visible. Hanger is now
ready for use.
4.
To remove hanger,
simply pull out of wall and fill small hole with putty
or spackling compound.
|
